Engine Removal/Installation - TOHATSU BFT115A Service Manual

ENGINE REMOVAL
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when han-
dling fuel.
• Keep heat, sparks, and flame away.
• Wipe up spills immediately.
• Handle fuel only outdoors.
Disconnect the negative (–) and positive (+) cables from
the battery.
Shift the remote control lever to the N (neutral) position.
Remove the following:
– L./R. side cover bracket (page 6-18)
– Under cover front bracket (page 6-18)
– Starter cable (page 10-9)
– Power tilt relay/connector bracket A (page 10-11)
– Fuel pump (high pressure side)/vapor separator
(page 5-101)
– Oil case/water tube (page 12-6)
– Shift link bracket (page 20-7)
– Seal holder (page 20-12)
– Water relief tube (page 11-6)
– Starter motor (page 9-5)
Relieve the fuel pressure (page 5-79).
Attach the engine chains (1) to the engine hangers (2).
Disconnect the air vent tube (1) and oil tube (2) from the
mounting case.

ENGINE REMOVAL/INSTALLATION

(1)
(2)
(1)
(2)
(2)
13-3