TOHATSU BFT115A Service Manual page 656

TRIM/TILT
Pull the brushes (1) from the brush holder A (2) and B
(3).
Disconnect the motor wire (Blue wire) terminal (4) from
the breaker (5) while holding the breaker with a
screwdriver.
• Do not disconnect the Blue wire terminal without
holding the breaker, or it can cause damage to the
breaker. Be sure to disconnect the terminal while
holding the breaker.
• Take care not to touch the bimetal part of the
breaker during removal.
Remove the two screws (6), motor wire (Green wire)
(7), brush holders A and B, brush, two brush springs (8)
and breaker.
Remove the O-ring (9) from the front bracket groove.
Check the oil seal (10) for damage or wear.
Replace the oil seal with a new one if necessary.
Check the metal part (11) of the front bracket for
damage and wear.
Replace the front bracket assembly if necessary.
19-44
(7)
(6)
(2)
(1)
(6)
(4)
(7)
(2)
(8)
(10)
(4)
(5)
(6)
(3)
(6)
(3)
(8)
(5)
(1)
(9)
(11)