TOHATSU BFT115A Service Manual page 187

3. EOP sensor signal line open or short circuit/
GND line open circuit inspection
Measure the voltage between the EOP sensor 3P
connector main wire harness side No.2
7
(Yellow/Red) terminal
terminal.
Is the measurement within 4.75 – 5.25 V?
YES – Replace the EOP sensor with a new one
and recheck.
NO – • Repair open or short in the Yellow/Red
wire
• Repair open in the Green/Red wire.
• If the main wire harness is normal,
replace the ECM with a new one, and
recheck.
and No.3 (Green/Red)
EOP SENSOR 3P CONNECTOR
MAIN WIRE HARNESS SIDE
7
SG2
(Green/Red)
POIL
(Yellow/Red)
FUEL SYSTEM
5-69