TOHATSU BFT115A Service Manual page 271

Check that the cover lock cable B (1) is positioned
under the R. engine under cover (2) as shown.
Install the tabs (1) of the rear side (cylinder head cover
side) of L. engine under cover (2) into the grooves (3) of
the R. engine under cover (4).
• Be sure that all tabs and grooves are completely
aligned with each other.
Install the three collars (1), then loosely install the three
screws (2) and five special bolts (3) to the R. engine
under cover (4).
• Be sure that the special bolt flange is positioned in
the case bolt hole.
Tighten the three screws and five special bolts to the
specified torque in the numbered order in several steps.
TORQUE:
Screws: 4.5 N·m (0.46 kgf·m, 3.3 lbf·ft)
Special bolts: 10 N·m (1.0 kgf·m, 7 lbf·ft)
• Be sure that all tabs and grooves are completely
aligned with each other.
ENGINE COVER/COVER LOCK
(2)
(1)
(2)
(2)
(1)
6
7
8
(1)/(2)
(4)
(1)
(4)
(3)
(4)
(3)
(3)
1
5
3
2
4
6-13