TOHATSU BFT115A Service Manual page 610

MOUNT
ASSEMBLY
Apply engine oil to the outer circumference of a new
needle bearing (1).
Install the needle bearing in the mounting case using
the special tools as shown.
TOOLS:
Driver (2)
Attachment, 28 × 30 mm (3)
Pilot, 20 mm (4)
Apply marine grease to the outer circumference of a
new water seal (14 × 26 × 8 mm) (1).
Install the water seal in the mounting case using the
special tools as shown, noting the installation direction.
TOOLS:
Driver (2)
Attachment, 24 × 26 mm (3)
After installation, apply 2 – 4 g of marine grease to the
lips and nearby surface of the water seals.
Apply engine oil to the inner surface of a new inner ring
(1).
Using a press, install the inner ring to the shift shaft A
(2) so that the distance between the inner ring face and
shift shaft A surface is 1.0 mm (0.04 in) (3) as shown.
18-8
07749-0010000
07946-1870100
07746-0040500
(2)
(3)
07749-0010000
07746-0010700
(1)
(1)
(2)
(3)
(4)
(3)
(1)
(2)