TOHATSU BFT115A Service Manual page 325

Install the brush holder (1) onto the armature (2).
Apply grease to the armature shaft.
Install the rear bracket (3).
Apply water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seating surface of
each screw (4).
Install and tighten the two screws to the specified
torque.
TORQUE: 2.5 N·m (0.26 kgf·m, 1.8 lbf·ft)
Check the inner wall of the yoke (1) for foreign material.
Install the armature/rear bracket assembly (2) by
aligning the grommet (3) with the cutout (4) in the yoke.
Install the plate (1) and packing (2) on the front bracket
(3).
Install the yoke/rear bracket assembly (4) by aligning
the projection (5) on the yoke with the cutout (6) in the
front bracket.
Apply water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seating surface of
each bolt (7).
Install and tighten the two bolts to the specified torque.
TORQUE: 5 N·m (0.51 kgf·m, 3.7 lbf·ft)
STARTING SYSTEM
(4)
(2)
(3)
(4)
(4)
(7)
(6)
(3)
(3)
(1)
(2)
(1)
(7)
(2)
(5)
(1)
9-13