TOHATSU BFT115A Service Manual page 222

FUEL SYSTEM
Connect the fuel tube B (1) to the vapor separator.
Connect the pressure regulator return hose (1) to the
vapor separator (2).
Connect the air vent tube E (3) to the vapor separator,
then clamp the air vent tube E and fuel hose (4) with the
hose clip (5).
Apply engine oil to two new O-rings (1) and install them
to the joint pipe (2).
Insert the joint pipe until it is seated on the fuel line (3).
Install the fuel hose (4) to the fuel line and tighten the
bolt (5).
To prevent fuel leaks, make sure the fuel pipe joint and
fuel hose are fixed to the fuel line securely before
tightening the bolt.
Connect the fuel pump 2P connector (1) and install it to
the connector bracket (2).
Install the harness band clip (3) to the connector
bracket as shown.
Set the cover lock cable (4) and fuel tube D (5) to the
clamps (6).
5-104
(1)
(5)
(1)
(2)
(3)
(5)
(3)
(5)
(4)
(3)
(4)
(1)
(2)
(1)
(4)
(1)
(2)
(6)