TOHATSU BFT115A Service Manual page 554

GEAR CASE (COUNTER ROTATION)
GEAR CASE REMOVAL/INSTALLATION
REMOVAL
Set the remote control lever in the "N" (Neutral)
position.
Tilt up the motor to the uppermost position.
Remove the bolt (10 × 32 mm) (1) and gear case cover
(2).
Remove the seven bolts (10 × 40 mm) (3) while
supporting the gear case (4).
Remove the gear case with care not to damage the
vertical shaft (5).
Remove the shift rod A (6) and two dowel pins (7).
After removing the gear case, tilt down the motor to the lowermost position.
(SPLINE AREA)
(5)
(6)
(7)
(3)
34 N·m (3.5 kgf·m, 25 lbf·ft)
17-8
(WATER TUBE SEAL
RING INNER SURFACE)
(4)
(2)
(1)