TOHATSU BFT115A Service Manual page 545

Apply gear oil to the outer circumference of a new
needle bearing (28.575 x 44.45 x 31.75 mm) (1).
Install the needle bearing into the gear case (2) using
the special tools.
• Install the needle bearing with the stamped side
facing down (facing the special tool side).
TOOLS:
Installer shaft, 15 x 370 mm (3)
Attachment, 78 x 90 mm (4)
Oil seal driver attachment,
27.5 x 44 mm (5)
After installation, check that the bottom surface of the
needle bearing is flush with the bottom of the gear case.
GEAR CASE (STANDARD ROTATION)
07VMF-KZ30200
07GAD-SD40101
07948-9540000
(5)
(3)
(1)
(4)
(2)
16-51