TOHATSU BFT115A Service Manual page 601

GEAR CASE BEARING REPLACEMENT
NEEDLE BEARING
Set the special tools on the needle bearing (28.575 x
44.45 x 31.75 mm) (1), and place a shop towel (2) or
equivalent material under the needle bearing as shown.
TOOLS:
Driver, 280 mm (3)
Bearing remover attachment,
37 mm (4)
Pilot, 35 mm (5)
Remove the needle bearing from the gear case (6).
• Remove the needle bearing with care not to damage
the gear case.
Apply gear oil to the outer circumference of a new
needle bearing (28.575 x 44.45 x 31.75 mm) (1).
Install the needle bearing into the gear case (2) using
the special tools.
• Install the needle bearing with the stamped side
facing down (facing the special tool side).
TOOLS:
Installer shaft, 15 x 370 mm (3)
Attachment,
78 x 90 mm (4)
Oil seal driver attachment,
27.5 x 44 mm (5)
After installation, check that the bottom surface of the
needle bearing is flush with the bottom of the gear case.
GEAR CASE (COUNTER ROTATION)
(4)
07949-3710001
07ZMD-MBW0200
07746-0040800
(5)
(2)
07VMF-KZ30200
07GAD-SD40101
07948-9540000
(5)
(3)
(3)
(1)
(1)
(6)
(4)
(2)
17-55