CONTROLS
Pull the click arm (1) as shown direction and hold it,
(5)
then install the neutral switch bracket by aligning the
(4)
hole (2) with the projection (3) on the seal holder.
Install and tighten the bolt (4).
Install the fuel tube A (5) to the fuel tube holder (6).
(3)
(1)
(6)
(2)
Apply marine grease to the link pin inserting area and
roller contact area of the shift arm (1).
(1)
Pull the click arm (2) as shown direction and hold it,
then install the shift arm to the shift shaft B (3).
(3)
(2)
Set the washer (1) to the shift shaft B (2) and install the
(3)
snap pin (3) to the shift shaft B.
Install the shift link bracket (page 20-7).
(1)
(2)
20-11