TOHATSU BFT115A Service Manual page 626

TRIM/TILT
Inspect the anode metal (1) for corrosion and replace if
necessary.
Install the anode metal and ground cable (2) and tighten
the two bolts (3).
Set the ground cable in the specified angle as shown,
and tighten the screw (4).
Loosen the manual valve (1) fully.
Raise the swivel case assembly a little, unlock the tilt
stopper and lower the swivel case assembly to the
lowermost position.
With the swivel case assembly in its lowermost position,
tighten the manual valve to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Install the swivel case/stern bracket to the boat.
Install the mounting case (page 18-4).
Lift up the outboard motor using the engine hanger until
the stud bolts (1) are aligned with the mount frame
holes (2) of the stern bracket/swivel case (3).
Move the stern bracket/swivel case assembly, which is
attached to the outboard motor stand, slowly toward the
outboard motor.
Insert the stud bolts into the mount frame holes and
tighten the two self-locking nuts (4) to the specified
torque.
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
19-14
(1)
(2)
90°
(1)
Tighten
(4)
(2)
(3)
(4)
(3)
(3)
Loosen
(1)