GEAR CASE (STANDARD ROTATION)
SHIFT SLIDER/BEARING HOLDER/
PROPELLER SHAFT REMOVAL/
INSTALLATION
SHIFT SLIDER REMOVAL
Remove the propeller shaft holder (page 16-21).
Remove the cross pin ring (1), shifter pin (2) and clutch
shifter (3).
Remove the shift slider (1) and two steel balls (#7) (2)
from the propeller shaft (3), being careful not to lose the
steel balls.
Remove the circlip (1) from the shift slider (2).
Remove the roller (1) from the shift slider (2) using a
commercially available pin driver (3).
• Take care not to let the shift plate, shift springs and
steel balls (#9) pop out of the shift slider during
removal of the roller.
16-22
(2)
(3)
(1)
(3)
(2)
(1)
(3)
(1)
(1)
(2)
(2)