TOHATSU BFT115A Service Manual page 679

CONTROLS
ADJUSTMENT
Move the remote control lever to the "N" (Neutral)
position.
(2)
Loosen the lock nut (1) of the remote control cable (shift
(1)
side) and remove the shift pivot (2) from the shift link pin
(3).
Make sure that the roller (4) of the click arm is in the
groove (5) of the shift arm.
Turn the shift pivot so that the shift pivot sets on the
shift pin smoothly.
Set the shift pivot to the shift link pin and move the
(3)
remote control lever several times, then move the
remote control lever to the "N" (Neutral) position.
Make sure that the roller of the click arm is in the groove
of the shift arm and neutral switch tip area (6) is pushing
the click arm flat area (7).
After checking, tighten the lock nut.
(2)
If the roller is not in the groove, readjust the shift control
cable.
(1)
Install the front separate cover (page 6-3).
(7)
(5)
(6)
(4)
20-17