Throttle Control Cable - TOHATSU BFT115A Service Manual

CONTROLS

THROTTLE CONTROL CABLE

REMOVAL/INSTALLATION
REMOVAL
Remove the front separate cover (page 6-3).
Remove the shift control cable (1) by sliding the lock
plate (2) of the shift pivot (3) as shown.
Loosen the shift pivot lock nut (4) and remove the shift
pivot from the throttle control cable.
INSTALLATION
Before installing the cable to the outboard motor, check
that the cable is connected to the remote control box
side properly.
Apply marine grease to the mating surface of the
throttle arm link pin and shift pivot bearing area.
Install the shift pivot (1) to the throttle control cable (2).
Install the shift pivot to the throttle arm (3).
Lock the lock plate (4) by sliding it into the groove of the
throttle arm.
After installation, inspect and adjust the throttle link
(page 3-9).
20-6
(3)
(2)
(4)
(3)
(1)
(2)
(1)
(4)
(1)