TOHATSU BFT115A Service Manual page 244

FUEL SYSTEM
Install a new O-ring (1) to the fuel pump case (2).
Connect the Blue/Yellow terminal (3) to the fuel pump
positive (+) terminal (4).
Connect the Black terminal (5) to the fuel pump
negative (-) terminal (6).
Install the pump cover (1) and connector bracket (2).
Install and tighten the four screws (3) to the specified
torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Install the harness clip (4) and tube clip (5) to the
connector bracket.
Set the spring (1) to the pump cover (2).
Apply engine oil to a new O-ring (3) and install it to the
strainer cover (4).
Install the strainer packing (5) to the fuel strainer (6).
Set the fuel strainer to the strainer cover.
Install the strainer cover to the pump cover and tighten
the three screws (7) to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Install the service check bolt (8) with a new sealing
washer (9) and tighten it to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install two new O-rings (1) to the vapor separator (2).
Install the fuel pump (high pressure side)/fuel strainer
assembly (3) to the vapor separator.
Install the four bolts (6 × 25 mm) (4) and tighten them to
the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Apply engine oil to two new O-rings (5) and install them
to the joint pipe (6).
Install the joint pipe until it is seated on the strainer
cover (7).
Set the fuel hose (8) on the strainer cover and tighten
the bolt (6 × 25 mm) (9).
Make sure the fuel hose joint and fuel hose are seated
on the strainer cover before tightening the bolt.
Install the fuel pump (high pressure side)/vapor
separator (page 5-103).
5-126
(5)
(6)
(1)
(2)
(3)
(1)
(1)
(6)
(3)
(4)
(9)
(7)
(8)
(2)
(3)
(4)
(9)
(8)
(5)
(7)
(3)
(4)
(3)
(2)
(4)
(5)
(2)
(5)
(1)
(6)