TOHATSU BFT115A Service Manual page 231

MAP SENSOR REMOVAL/
INSTALLATION
Remove the silencer case (page 5-83).
Disconnect the MAP sensor 3P connector (1).
Remove the screw (2), harness clamp holder (3) and
MAP sensor (4).
Remove the O-ring (1).
Apply engine oil to a new O-ring and install it to the
MAP sensor.
Install the MAP sensor and harness clamp holder to the
throttle body, then install and tighten the screw to the
specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Connect the MAP sensor 3P connector.
Install the silencer case (page 5-83).
IAT SENSOR REMOVAL/
INSTALLATION
Remove the engine cover.
Disconnect the 2P connector (1) and remove the IAT
sensor (2).
Installation is in the reverse order of removal.
(1)
(1)
(2)
FUEL SYSTEM
(4)
(2)
(3)
(1)
5-113