TOHATSU BFT115A Service Manual page 213

INSTALLATION
Apply engine oil to the new O-ring (7.47 × 3.6 mm) (1)
and O-ring (7.45 × 3.61 mm) (2) and install them into
the grooves of the fuel injector (3).
• Be sure to install the O-rings in their correct
locations.
Install the fuel injectors (1) by aligning their tabs (2) with
the grooves (3) of the fuel pipe.
Insert the fuel injectors straight into the fuel pipe. Do not
insert them into the fuel pipe slanted, and do not insert
them with force. Damage to the O-rings can occur.
Install injector clips (4) and tighten the bolts (5) to the
fuel pipes.
To prevent damage to the O-ring, install the injectors in
the fuel pipe first, then install them in the injector bases.
Apply engine oil to the new O-rings (1) and install the
fuel line (2), then tighten the two nuts (3).
Set the air vent tube (4) and fuel tube B (5) to the four
14 mm tube clips (6).
(3)
(2)
(2)
(5)
(4)
(3)
(4)
(5)
FUEL SYSTEM
(1)
(1)
(1)
(6)
(2)
(3)
5-95