TOHATSU BFT115A Service Manual page 204

FUEL SYSTEM
CLEANING
Wipe off carbon or any other dirt or stain with soft dry
shop towels sprayed with carburetor cleaner, and clean
the throttle valve and bore.
• The inside of the throttle body is coated with
molybdenum. Do not wipe the molybdenum coated
area (1) of throttle valve.
INSTALLATION
Install a new throttle body packing (1) to the intake
manifold (2).
Install the throttle body (3) and tighten the four bolts (4)
to the specified torque in the numbered order in two or
three steps.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Apply marine grease to the throttle body insertion area
and throttle plate insertion area of the throttle rod (1).
Install the throttle rod in the direction as shown.
• Do not loosen the throttle rod lock nut.
5-86
(4)
(1)
1
4
(3)
3
2
(1)
(1)
(2)