TOHATSU BFT115A Service Manual page 403

Connect the CMP sensor 3P connector and install the
harness band clip (2) to the clip bracket F (3).
Install the R. side cover bracket (1) and tighten the bolts
(2).
Install the following:
– Direct ignition coils (page 3-17)
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
CRANKSHAFT PULLEY/CAM CHAIN
REMOVAL/INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable.
Make sure the remote control lever is in "N" (neutral)
position.
Remove the following:
– Alternator belt (page 7-5)
– Thermostat (page 11-5)
– Engine hanger B (page 7-7)
– Cylinder head cover (page 14-6)
Turn the crankshaft pulley (1) clockwise so that the cut-
out (2) of the crankshaft pulley lines up with the pointer
(3).
Make sure that the marks (4) of intake cam sprocket (5)
and exhaust cam sprocket (6) are lined up as shown. In
this position, the No. 1 piston is at TDC.
CYLINDER HEAD
(2)
(2)
(3)
(4)
(6)
(3)
(1)
(1)
(2)
(1)
(5)
14-11