TOHATSU BFT115A Service Manual page 277

Remove the trim angle sensor 3P connector (1) and
power tilt motor 2P connector (2) from the connector
bracket A.
Disconnect the trim angle sensor 3P connector and
power tilt motor 2P connector.
Release the under case grommet C (1) from the under
cover front bracket (2) toward out side as shown.
Pull out the connectors (3) from the under cover front
bracket hole (4).
Remove the two washer bolt (1) and under cover front
bracket (2).
Installation is in the reverse order of removal.
POWER TILT SWITCH REMOVAL/
INSTALLATION
Remove the R. engine under cover (page 6-10).
Remove the power tilt switch (1) from the holder (2) and
R. engine under cover (3) by pressing the tabs inward.
Installation is in the reverse order of removal.
ENGINE COVER/COVER LOCK
(2)
(4)
(2)
(1)
(2)
(1)
(1)
(2)
(3)
(1)
(3)
6-19