TOHATSU BFT115A Service Manual page 569

Remove the shift plate (1) from the shift slider (2), then
remove the two shift springs (3) and two steel balls (#9)
(4).
• Take care not to let the shift springs and steel balls
(#9) pop out of the shift slider during removal of the
shift plate.
PROPELLER SHAFT REMOVAL
Prepare the fixing tool with the dimensions shown.
Position the propeller shaft holder (1) onto the fixing tool
(2) and secure the holder with bolts (3).
Hold the fixing tool with a vise.
• Avoid holding the propeller shaft holder directly in a
vise. Use the fixing tool to hold it in a vise.
Loosen the bearing holder (4) using the special tool as
shown.
TOOL:
Pin spanner wrench, 110 mm (5) 07WAA-S1G0100
Remove the bearing holder from the propeller shaft
holder.
Remove the thrust bearing washer (1) from the
propeller shaft (2).
Remove the following parts from the propeller shaft
holder (3):
– Propeller shaft
– Thrust bearing (4)
– Thrust bearing washer (5)
– Thrust shim (6)
– O-ring (7)
GEAR CASE (COUNTER ROTATION)
(1)
(4)
(2)
60 mm (2.4 in)
Φ10 (0.4 in)
300 mm
(11.8 in)
30 mm
(1.2 in)
69.5 mm
(2.74 in)
69.5 mm
(2.74 in)
(4)
(1)
(2)
(3)
Φ35 (1.4 in)
Φ10
(0.4 in)
(5)
(2)
(3)
(1)
(4)
(5)
(6)
(7)
(3)
17-23