TOHATSU BFT115A Service Manual page 235

ECT SENSOR 2 REMOVAL/
INSTALLATION
Remove the engine cover.
Disconnect the ECT sensor 2 (2P) connector (1).
Remove the ECT sensor 2 (2).
Remove the O-ring (1).
Apply engine oil to a new O-ring and install it to the ECT
sensor 2 (2).
Apply liquid sealant (Threebond® 1201 or 1215 or
equivalent) to the threads and seating surface of the
ECT sensor 2.
Install the ECT sensor 2 to the chain case and tighten it
to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the ECT sensor 2 (2P) connector.
Install the engine cover.
ECT SENSOR 3 REMOVAL/
INSTALLATION
Remove the engine cover.
Disconnect the ECT sensor 3 (2P) connector (1).
Remove the ECT sensor 3 (2).
Remove the O-ring (1).
Apply engine oil to a new O-ring and install it to the ECT
sensor 3 (2).
Apply liquid sealant (Threebond® 1201 or 1215 or
equivalent) to the threads and seating surface of the
ECT sensor 3.
Install the ECT sensor 3 to the exhaust manifold and
tighten it to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the ECT sensor 3 (2P) connector.
Install the engine cover.
(1)
(1)
(2)
(1)
(1)
FUEL SYSTEM
(2)
(2)
(2)
5-117