TOHATSU BFT115A Service Manual page 573

GEAR CASE (COUNTER ROTATION)
SHIFT SLIDER INSTALLATION
Install a shift spring (1), two steel balls (#9) (2), the
(3)
other shift spring and shift plate (3) into the shift slider
(2)
(4) in this order.
(5)
Install the roller (5) by aligning the hole in the shift slider
with the hole in the shift plate, then install the circlip (6).
(4)
(1)
(6)
Set the two steel balls (#7) (1) in the steel ball
(2)
installation holes of the shift slider (2), and push the
shift slider slowly into the propeller shaft (3).
• Push the shift slider into the propeller shaft with care
not to allow the steel balls (#7) to pop out.
(3)
(1)
With the F mark (1) of the clutch shifter (2) toward the
reverse bevel gear (cruising direction) (3), install the
(1)
clutch shifter onto the propeller shaft while aligning the
shifter pin installation hole (4) with the long hole of the
propeller shaft (5).
(2)
(3)
(4)
(5)
17-27