TOHATSU BFT115A Service Manual page 523

Install the cross pin ring (1) onto the clutch shifter (2).
• Check that the coils of the cross pin ring do not
overlap with each other.
Check that the steel balls (#7) (1) are positioned in the
groove (2) of the propeller shaft (3) as shown.
Note that the shift rod cannot be installed unless the
shift slider (4) is in the correct position. Set the shift
slider on the position as shown.
Install the propeller shaft holder (page 16-21).
VERTICAL SHAFT REMOVAL/
INSTALLATION
REMOVAL
Remove the propeller shaft holder (page 16-21).
Attach the special tool to the vertical shaft (1) end
(flywheel boss installation side).
TOOL:
Vertical shaft holder (2)
Place a shop towel (3) or equivalent material as shown
to protect the gear case (4).
Holding the vertical shaft with the special tool as shown,
remove the pinion gear nut (5) and pinion gear (6) from
the vertical shaft.
Remove the lock nut (1) using the special tool.
TOOL:
Lock nut wrench, 36 × 47.8 mm (2) 07916-MB00002
Remove the vertical shaft (3).
• Be careful not to drop the needle bearing (rollers)
when removing the vertical shaft.
GEAR CASE (STANDARD ROTATION)
(2)
(1)
07SPB-ZW10200
(6)
(2)
(1)
(2)
(1)
(2)
(5)
(3)
(3)
(4)
(4)
(3)
(1)
16-29