TOHATSU BFT115A Service Manual page 274

ENGINE COVER/COVER LOCK
Insert the inner cable end of cover lock cable A (1) into
the front lock arm (2).
Install cover lock cable A to the under cover front
bracket (3), and tighten the washer side lock nut (4) to
the specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
• After tightening the lock nut, check that the adjusting
nut position is not changed from the previous step.
If changed, readjust the cable.
Install the vinyl tube (5) and fuel tube (6) to the under
cover front bracket.
Insert the inner cable end of cover lock cable A (1) into
the L. side lock (2).
Install cover lock cable A to the L. side cover bracket
(3), and tighten the washer side lock nut (4) to the
specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
• After tightening the lock nut, check that the adjusting
nut position is not changed from the previous step.
If changed, readjust the cable.
There should be no clearance (5) between the hole of
the L. side lock and cable end of the cover lock cable A,
and check that the L. side lock is contacting the stopper
(6) of the L. side cover bracket.
Readjust the cable if there is clearance.
Set the adjusting nut position of cover lock cable B (1)
(shorter cable) to the measurement as shown.
6-16
(5)
(3)
(6)
(4)
(1)
(2)
(3)
(1)
(5)
13 mm (0.6 in)
L. SIDE LOCK
13 mm (0.6 in)
(1)
(2)
(4)
(1)
(6)
(6)
(2)
R. SIDE LOCK