TOHATSU BFT115A Service Manual page 39

VIEWED FROM THE RIGHT FRONT SIDE
HARNESS BAND CLIP
Clamp the starter cable (+) 2 and power
trim/tilt switch wire.
POWER TRIM/TILT
SWITCH WIRE
STARTER CABLE (+) 2
Viewed from the silencer case side:
HARNESS BAND CLIP
Clamp the starter cable (+) 1 and
starter cable (+) 2.
STARTER CABLE (+) 2
(To starter motor B terminal)
STARTER CABLE (+) 1
(To fuse/relay junction box)
Viewed from the upper side:
HARNESS BAND CLIP
Clamp the starter cable (+) 1, starter cable (+) 2 and starter cable (+).
STARTER CABLE (+) 1
(To fuse/relay junction box)
STARTER CABLE (+)
(To starter motor B terminal)
GND1
STARTER CABLE GROUND TERMINAL
Connect the ground terminal by pushing it
against the projection on the crankcase.
PROJECTION
STARTER CABLE
GROUND TERMINAL
Viewed from the front side:
SERVICE INFORMATION
STARTER CABLE (+) 2
(To power trim/tilt relay)
Viewed from the front side:
STARTER CABLE (+) 2
CABLE BRACKET A
Clamp the starter cables and starter
cable (+) 2.
STARTER CABLES
Viewed from the front side:
STARTER CABLES
STARTER CABLE (+) 2
(To power trim/tilt relay)
ENGINE
SIDE
2-23