CYLINDER BLOCK
Align the rear balancer shaft boss (1) with the index
mark (2) of balancer case.
Hold the rear balancer shaft (3) by inserting a special
tool (4) into the shaft through the maintenance hole (5).
TOOL:
Pin driver 6.0 (4)
Install the balancer chain to the crankshaft sprocket by
aligning its color plate (one place) (1) with the index
mark (2) of crankshaft sprocket.
Set the driven sprocket to the balancer chain by
positioning its punch mark (1) between the color plates
(two places) (2) of balancer chain.
Install the driven sprocket by aligning its groove (3) with
the boss (4) of the rear balancer shaft.
Apply engine oil to the threads and seating surface of
the bolt (5) and tighten it to the specified torque.
TORQUE: 45 N·m (4.6 kgf·m, 33 lbf·ft)
After installation, remove the special tool from the
balancer case assembly.
15-12
07744-0010500
(5)
(1)
(1)
(3)
(5)
(2)
(1)
(4)
(2)
(3)
(2)
(4)