TOHATSU BFT115A Service Manual page 659

• Make sure that there is no washer, etc. on the
magnet in the yoke (1).
Wrap the armature shaft (2) with a shop towel (3) or
equivalent material, and hold the shaft with pliers (4).
Pulling the two motor wires (5) of the yoke side slowly,
install the armature/front bracket (6) on the yoke.
If it is hard to install the armature/front bracket in the
yoke, check whether the metal of the yoke (i.e. where
the armature shaft is installed) is out of position and
repeat.
After installation, check that the armature turns
smoothly and tighten the two screws (7).
After tightening the two screws, connect the motor 2P
connector and check whether the motor turns. If the
motor does not turn, disassemble the power tilt motor
again, and check whether the motor wire (Blue wire)
terminal is disconnected.
Install the two grommets (1) and wire holder (2) on the
yoke (3).
Tighten the screw (stainless steel screw) (4) to the
specified torque. Do not overtighten it.
TORQUE: 1.4 N·m (0.14 kgf·m, 1.0 lbf·ft)
Tape the corrugated tube (1) with heat resisting tape (2)
so that the distance from the wire holder end (3) to the
tube end is 30 mm (1.2 in) or less (4) as shown.
• Wrap the heat resisting tape 2 - 3 times around the
tube.
Install the power tilt motor to the power trim/tilt (page
19-36).
Bleed air from the power trim/tilt without mounting on
the outboard motor (page 19-37).
(6)
(3)
(2)
(4)
(2)
(1)
(2)
(4)
TRIM/TILT
(5)
(1)
(7)
(4)
(3)
(1)
(3)
19-47