STARTING SYSTEM
Install the spring (1) and plunger (2) to the starter
solenoid (3), then assemble the plunger and clutch fork
(4) as shown.
Apply engine oil to new O-rings (5) and install them
onto the screws (6).
Install and tighten the two screws to the specified
torque.
TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)
Connect the motor wire (7) to the M terminal (8) and
tighten the nut (9).
WATER RESISTING SEALANT
APPLICATION POINTS
After the assembling the starter motor, apply a sufficient
amount of water-resisting sealant (Sumitomo 3M
Padding Sealer 8533 or equivalent) to the mating
surfaces as shown.
– Packing/front bracket mating section (1)
– Starter solenoid/front bracket mating section (2)
– Starter solenoid mounting screw (3)
– Screw/ bolt and rear bracket mating sections (4)
– Wire, grommet and rear bracket (5)
– Engagement sections with yoke (6)
– Starter solenoid case caulking section (7)
9-14
(5)
(6)
(8)
(4)
(6)
(1)
(3)
(1)
(2)
(4)
(2)
(9)
(7)
(1)
(7)
(5)
(7)
(2)
(3)