TOHATSU BFT115A Service Manual page 612

MOUNT
Install the upper rubber mount (1) to the mounting case
(2) with its "UP" mark (3) facing up.
Install the two stud bolts (4) with its longer thread side
facing the upper rubber mount.
Install a new upper mount holder gasket (1) and upper
mount holder (2) with their cutouts (3) positioned as
shown, and tighten the six bolts (4).
Apply marine grease to the outer surface of the shift
shaft A (1) and needle bearing (2) inner surface.
Install the shift shaft A, washer (3) and E-ring (4) to the
mounting case (5).
Install the mounting case (page 18-4).
18-10
(4)
(2)
(4)
Short
(4)
(1)
(1)
(5)
(3)
(4)
(3)
(1)
Long
Upper rubber
mount side
(2)
(3)
(2)