TOHATSU BFT115A Service Manual page 639

Remove the internal circlip (1) and manual valve (2)
from the pump assembly (3).
Check the manual valve for wear or damage and
replace it if necessary.
Hold the cylinder (1) in a vise (2) with shop towel or soft
jaws as shown.
• Do not tighten the vise excessively, as it can
damage the cylinder.
Make sure that the left and right piston rods B are in the
fully extended position.
Loosen the rod guide (1) using the special tool as
shown.
TOOL:
Trim cap wrench, 4 mm (2)
Remove the rod guides (1) and piston rods B (2) from
the cylinders slowly.
Remove the rod guide from the piston rod B.
Drain the ATF from the cylinders.
(1)
(2)
070PA-0010100
(2)
(1)
(2)
TRIM/TILT
(3)
(1)
(2)
(1)
19-27