TOHATSU BFT115A Service Manual page 267

Check that the harness clips (1) and harness tapes (2)
of the power tilt motor wire (3) are aligned.
Position the clips while aligning their edges with the L.
engine under cover projections (4), then install and
tighten the two rivet screws (5).
Install the under cover grommet (1) onto the idle
exhaust port (2).
Install the four under cover grommet bosses (3) into the
engine under cover holes (4) securely.
Set the six mud guard clips (5) by aligning the clip holes
of under cover grommet and engine under covers.
Push in the heads of the mud guard clips (1) completely
in the numbered order.
Check that the lip (2) behind the under cover grommet
is completely set on the engine under covers.
• Be sure that the under cover grommet is fully seated
on the engine under covers.
ENGINE COVER/COVER LOCK
(5)
(5)
(2)
(4)
(1)
(2)
(4)
(3)
(2)
5
1
3
(1)
(1)
(3)
(5)
(1)
(2)
(5)
(1)
6
2
4
6-9