TOHATSU BFT115A Service Manual page 658

TRIM/TILT
ASSEMBLY
Apply marine grease to the oil seal lips.
Apply marine grease to a new O-ring (1) and install it to
the front bracket (2) groove.
Set the brush holder A (3) and motor wire (Green wire)
terminal (4), then install the brush terminal (5) and
loosely tighten the screw (6).
Be sure that the motor wire (Green wire) terminal and
the brush assembly wire terminal contact the respective
projections (7) on brush holder A, and then tighten the
screw.
Install the breaker (8) and brush holder B (9), and
tighten the screw (10).
Do not touch the bimetal part of the breaker.
Connect the motor wire (Blue wire) terminal (11) to the
breaker.
Install the two springs (12) in the place under the brush
holders A and B.
Set the two brushes (13) on the brush holders.
Apply marine grease to the sliding surface of the
armature shaft (1).
• Take care that the commutator surface (2) is not
contaminated with grease.
Install the armature on the front bracket while pushing
the brush terminal into the holder.
• Be careful not to damage the brushes when
installing the armature into the front bracket.
19-46
(6)
(11)
(5)
(4)
(3)
(2)
(7)
(4)
(6)
(7)
(5)
(1)
(3)
(2)
(10)
(9)
(8)
(13)
(1)
(12)
(11)
(8)
(10)
(9)
(13)
(1)
(1)