TOHATSU BFT115A Service Manual page 300

CHARGING SYSTEM
ASSEMBLY
If the front bearing is removed, replace with a new
bearing (1).
Apply grease to the outer circumference of the bearing.
Install a new front bearing in the stator (drive end
frame) using the special tool as shown.
TOOLS:
Driver (2)
Attachment, 37 x 40 mm (3)
Pilot, 15 mm (4)
Install the two stud bolts (1) to the stator (drive end
frame) (2),
Install the front bearing retainer (3) with its tabs (4)
facing the front bearing side and tighten the four screws
(5).
7-14
07749-0010000
07746-0010200
07746-0040300
(2)
(4)
(3)
(4)
(1)
(3)
(1)
(5)
(2)