TOHATSU BFT115A Service Manual page 33

CABLE/HARNESS ROUTING
VIEWED FROM THE UPPER RIGHT REAR SIDE:
HARNESS BAND CLIP
Clamp the main wire harness and the ECT sensor 3
wire as shown.
ECT SENSOR 3 WIRE
MAIN WIRE
HARNESS
Viewed from the cylinder head cover side:
WATER TUBE CLAMP
Set the water relief tube A in the
clamp the larger diameter side
and the main wire harness in
the clamp the smaller diameter
side.
MAIN WIRE
HARNESS
ECT SENSOR 3
2P CONNECTOR
ECT SENSOR 2
2P CONNECTOR
Clamp the main wire harness and the ECT sensor 3
wire as shown.
ECT SENSOR 3 WIRE
MAIN WIRE
HARNESS
Viewed from the cylinder head cover side:
HARNESS BAND CLIP
After securing the cables and harnesses
with the harness band clips, cut the end of
the harness band clips so that the projected
length is 5 – 10 mm (0.2 – 0.4 in) as shown.
HARNESS BAND CLIP
ECT SENSOR 4
2P CONNECTOR
SERVICE INFORMATION
5 - 10 mm
(0.2 -0.4 in)
A/F SENSOR
4P CONNECTOR
ALTERNATOR 4P
CONNECTOR
ALTERNATOR
B TERMINAL
ECT SENSOR 1
2P CONNECTOR
EOP SENSOR
3P CONNECTOR
2-17