TOHATSU BFT115A Service Manual page 168

FUEL SYSTEM
DTC 141-2 (ECT SENSOR 3 VOLTAGE IS TOO HIGH)
• When the DTC code 6-2, 7-2, 10-2, 22-2, 140-2,
141-2, and 143-2 are indicated at the same time, the
ground line (SG2) is open.
1. Symptom reproduction test
Turn the combination switch OFF.
Disconnect the ECT sensor 3 (2P) connector
ECM connector A
and joint connector 2
them.
Clear the DTC (page 5-6).
• Continue the procedure if the DTC does not
clear.
Turn the combination switch ON.
Measure the ECT sensor 3 voltage using the HDS.
Is the measurement within 0.08 – 4.92 V?
YES
NO
2. ECT sensor 3 signal/GND line open circuit
inspection
Turn the combination switch OFF and disconnect
the ECT sensor 3 (2P) connector
Turn the combination switch ON.
Measure the voltage between the ECT sensor 3
(2P) connector
(Red) terminal and No.2 (Green/Red) terminal.
Is the measurement within 4.75 – 5.25 V?
YES
NO
5-50
, ECM connector B
12
, and then reconnect
28
– Temporary failure (code
reappear)
– GO TO STEP 2.
main wire harness side No.1
8
– Replace ECT sensor 3 with a new one and
recheck.
– Repair open in the Red wire or Green/Red
wire. If the main wire harness is normal,
replace the ECM with a new one and
recheck.
,
8
,
13
does not
.
8
ECT SENSOR 3 (2P) CONNECTOR
MAIN WIRE HARNESS SIDE
SG2
(Green/Red)
8
TOH2
(Red)