TOHATSU BFT115A Service Manual page 418

CYLINDER HEAD
CAMSHAFT/ROCKER ARM REMOVAL/
INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable.
Make sure the remote control lever is in "N" (neutral)
position.
Turn the crankshaft and set the No. 1 piston at top dead
center of compression stroke (page 3-15).
Remove the crankshaft pulley/cam chain (page 14-11).
Loosen all the lock nuts (1) and then loosen all the
valve adjusting screws (2) fully.
Disconnect the CMP sensor 3P connector (1) and
remove the harness band clip (2) from the clip bracket F
(3).
Remove the two bolts (1), CMP sensor (2) and CMP
hole plug (3).
14-26
(1)
(3)
(2)
(3)
(1)
(2)
(1)
(2)