TOHATSU BFT115A Service Manual page 456

CYLINDER BLOCK
CRANKCASE/BALANCER REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– Main wire harness
– Intake manifold (page 5-87)
– Crankshaft pulley/cam chain (page 14-11)
– Flywheel (page 15-5)
– Fuel strainer (page 3-24)
– Water separator (page 5-99)
Remove the fifteen bolts (6×25 mm) (1) from the
crankcase (2).
Insert a screwdriver into the recesses (3) of the
crankcase and raise the crankcase little by little.
• Be careful not to damage the crankcase and cylinder
block mating surfaces.
Remove the two dowel pins (13×20 mm) (4) from the
cylinder block.
Align the punch mark (1) of driven sprocket with the
index mark (2) of balancer case.
Hold the rear balancer shaft (3) by inserting a special
tool (4) into the shaft through the maintenance hole (5).
TOOL:
Pin driver 6.0 (4)
15-8
(1)
(2)
07744-0010500
(5)
(3)
(4)
(4)
(2)
(1)
(3)