TOHATSU BFT115A Service Manual page 616

TRIM/TILT
POWER TRIM/TILT/SWIVEL CASE/
STERN BRACKET REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– Engine cover
– Switch panel cable/indicator wire (page 10-6)
– L. engine under cover (page 6-4)
– R. engine under cover (page 6-10)
– Gear case
– Standard rotation type (page 16-8)
– Counter rotation type (page 17-8)
Place the outboard motor on a level surface so it is in
the vertical position.
Remove the trim angle sensor 3P connector (1) and
power tilt motor 2P connector (2) from the connector
bracket A (3).
Disconnect the trim angle sensor 3P connector and
power tilt motor 2P connector.
Remove the under case grommet C (1) from the under
cover front bracket (2) toward the out side as shown.
Pull out the connectors (3) from the hole (4) of the
under cover front bracket.
Hook the engine hanger chains (1) to the three engine
hangers (2).
Remove the lower rubber mount.
– Standard rotation type (page 16-12)
– Counter rotation type (page 17-12)
• Check that the outboard motor is not lifted off.
19-4
(2)
(4)
(1)
(2)
(1)
(2)
(3)
(1)
(2)