TOHATSU BFT115A Service Manual page 57

VIEWED FROM THE LEFT REAR SIDE:
PRESSURE REGULATOR
RETURN HOSE
TUBE CLAMP D10.7
HOSE CLAMP
Set fuel tube E in the
larger diameter side of
the clamp and water tube
G in the smaller diameter
side of the clamp.
TUBE CLIP
FUEL
TUBE E
WATER TUBE G
WATER TUBE F
TUBE CLIP
B12
TUBE CLIP 65
Install with the lugs facing down.
TUBE CLIP
SENSOR HOSE CLIP
Clamp fuel tube B and fuel tube E.
·
· Install the sensor hose clip, aligning
with the end of the protection tube on
fuel tube E.
AIR VENT
TUBE A
TUBE CLIP
B12
TUBE CLIP (13 mm)
Clamp the
protection tube of
water tube F.
LUGS
FUEL TUBE B
PROTECTION
TUBE FUEL TUBE E
BREATHER
AIR VENT
TUBE
TUBE D
(12 x 740 mm)
TUBE CLIP 65
OIL TUBE
· Install the oil tube, aligning the
projection on the oil tube installation
part with the projection of the oil tube.
Install tube clamp D32.5 with the lugs
·
SENSOR
in the position shown.
HOSE CLIP
PROJECTION
PROJECTION
SERVICE INFORMATION
CHECK
VALVE
AIR VENT
TUBE C
AIR VENT
TUBE B
HOSE CLIP
Clamp air vent tube E and
fuel hose (high pressure
side).
FUEL
TUBE B
AIR VENT
TUBE E
FUEL TUBE D
SENSOR HOSE CLIP
Clamp fuel tube B and fuel
hose (high pressure side).
OIL TUBE
LUGS
2-41