TOHATSU BFT115A Service Manual page 219

FUEL PUMP (HIGH PRESSURE SIDE)/
VAPOR SEPARATOR REMOVAL/
INSTALLATION
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when han-
dling fuel.
• Keep heat, sparks, and flame away.
• Wipe up spills immediately.
• Handle fuel only outdoors.
Disconnect the battery cable from the battery negative
(–) terminal.
Remove the L. engine under cover (page 6-4).
Relieve the fuel pressure (page 5-79).
REMOVAL
Release the vapor separator drain tube (1) from the
clamp (2) on the under cover front bracket.
Loosen the water separator drain screw (1) and drain
the fuel in the vapor separator.
After draining, tighten the vapor separator drain screw
to the specified torque.
TORQUE: 1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
Release the high pressure side fuel pump 2P connector
(1) from the connector bracket (2) and disconnect it.
Release the harness band clip (3) from the connector
bracket.
Release the cover lock cable (4) and fuel tube (5) from
the clamps (6).
(2)
(3)
(5)
(4)
(6)
FUEL SYSTEM
(1)
(1)
(1)
(2)
5-101