TOHATSU BFT115A Service Manual page 55

VIEWED FROM THE UPPER LEFT SIDE:
PRESSURE REGULATOR CONTROL TUBE
Clamp the pressure regulator control tube,
aligning the marked part on the tube with the
end of the tube clip (3.5 mm).
PRESSURE REGULATOR
CONTROL TUBE
AIR VENT
TUBE A
HOSE CLAMP
Set the air vent tube B in the
lager diameter side of the
clamp and pressure regulator
return hose in the smaller
diameter side of the clamp.
TUBE CLIP
(3.5 mm)
MARKING
TUBE CLIP
(3.5 mm)
AIR VENT
TUBE B
PIPE CLAMP
Set the air vent tube A in the
lager diameter side of the
clamp and air vent tube D in
the smaller diameter side of the
clamp.
CLAMP
(18.5 mm)
BREATHER
TUBE
(12 x 740 mm)
AIR VENT
TUBE C
T-JOINT
SERVICE INFORMATION
FUEL TUBE CLAMP
Set breather tube in the larger
diameter side of the clamp and
pressure regulator control tube
in the smaller diameter side of
the clamp.
TUBE CLAMP
D25.0
WATER RELIEF
TUBE A
TUBE CLAMP
D10.7
Check that the
main wire
harness does not
interfere with the
tube clamp
D10.7.
AIR VENT TUBE D
CHECK VALVE
HOSE CLAMP
Set the air vent tube A in the
lager diameter side of the
clamp and pressure regulator
return hose in the smaller
diameter side of the clamp.
CLAMP
(18.5 mm)
PRESSURE
REGULATOR
RETURN
HOSE
2-39