TOHATSU BFT115A Service Manual page 291

ALTERNATOR REMOVAL/
INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable.
Remove the silencer duct (page 5-82).
Disconnect the 4P connector (1) from the alternator.
Remove the nut (2) and alternator fuse cable (3) from
the alternator B terminal (4).
Loosen the bolt (1) and nut (2).
Loosen the special adjuster bolt (3).
Move the alternator to the engine side as far as it goes,
and remove the alternator belt (4).
• Do not contaminate the alternator belt with oil and
grease after removal.
• Do not bend the alternator belt. Store the belt by
hanging it on the wall.
Remove the bolt (1), nut (2) and alternator (3).
INSTALLATION
Install the alternator (1) and loosely tighten the bolt (2).
Loosely install the nut (3).
CHARGING SYSTEM
(1)
(4)
(1)
(1)
(2)
(2)
(4)
(3)
(2)
(3)
(2)
(3)
(3)
(1)
7-5