TOHATSU BFT115A Service Manual page 674

CONTROLS
SEAL HOLDER REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– Shift arm/neutral switch (page 20-8)
– R. engine under cover (page 6-10)
Remove the bolt (6 x 14 mm) (1) and cable bracket A
(2).
Remove the starter cables (3) from the cable bracket A.
Remove the two bolts (6 x 20 mm) (4) and seal holder
(5).
• When removing the seal holder, hold the shift shaft
B (6) to prevent it from being disengaged from shift
shaft A.
• If disengage, adjust the shift shaft B alignment (page
20-18).
• If assembled with incorrect alignment, shifting
operation will fail.
Remove the O-ring (1) and oil seal (2) from the seal
holder.
20-12
(5)
(2)
(1)
(4)
(6)
(1)
(3)
(2)