TOHATSU BFT115A Service Manual page 512

GEAR CASE (STANDARD ROTATION)
INSTALLATION
Install the E-ring (1), washer (2), and shift rod spring (3)
onto the shift rod (4).
• Do not reuse the E-ring if it is deformed or
deteriorated.
• Check that the E-ring is set in the groove in the shift
rod securely.
Insert the shift rod (1) into the gear case by aligning the
cam (2) of the shift rod with the "A" point (3) of the gear
case as shown.
Install the shift rod onto the shift slider (4) by aligning
the cam of the shift rod with the groove (5) in the shift
slider.
• Check that there is no marking in the shift rod end
(6).
After installing the shift rod, position the shift rod in the
"N" (Neutral) position and check that the cutout in the
spline (7) faces the cruising direction (8).
16-18
(1)
(4)
(2)
(3)
(1)
(4)
(7)
(8)
(3)
(2)
(1)
(5)
(6)