TOHATSU BFT115A Service Manual page 635

Apply grease to the splines of the lower mount center
housing (1).
Install the lower mount center housing on the mount
frame (2) by aligning its " " mark (3) with the mark (4)
on the mount frame that had been made during
disassembly.
Apply heat to the lower mount center housing (1), using
a commercially available heat gun.
Overheating the lower mount center housing may
cause damage to the painted surfaces.
Set the swivel case/mount frame to the hydraulic press.
Set the special tool onto the lower mount center
housing as shown, press the lower mount center
housing until it seats on the swivel case.
TOOL:
Driver, 40 mm I.D. (2)
Remove the special tool and swivel case from the
hydraulic press.
(1)
07746-0030100
(3)
(4)
(1)
TRIM/TILT
(2)
(2)
19-23