TOHATSU BFT115A Service Manual page 292

CHARGING SYSTEM
Install the alternator belt (1) to the crankshaft pulley (2),
then alternator pulley (3).
Adjust the belt tension by turning the special adjuster
bolt (4) (page 3-9).
• Do not turn the crankshaft pulley counterclockwise.
After adjusting the belt tension, tighten the nut (5) first,
then the bolt (6) to the specified torque.
TORQUE:
Nut: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Bolt: 44 N·m (4.5 kgf·m, 32 lbf·ft)
After tightening the nut and bolt, recheck the belt
tension (page 3-8).
Set the alternator fuse cable (1) to the alternator B
terminal (2) in the specified angle as shown.
Install and tighten the nut (3) to the specified torque.
TORQUE: 8 N·m (0.82 kgf·m, 5.9 lbf·ft)
Install the terminal cover (4) to the alternator B terminal.
Connect the alternator 4P connector (5).
Install the silencer duct (page 5-82).
Connect the battery negative (–) cable.
7-6
(1)
(6)
(3)
(5)
(4)
60°
(2)
(5)
(4)
(3) (2)
(1)
(3)
(1)