TOHATSU BFT115A Service Manual page 205

Connect the MAP sensor 3P connector (1) and install
the harness band clip (2).
Connect the TP sensor 3P connector (1) and install the
harness band clip (2) to the sensor wire bracket (3).
Install the water level sensor 2P connector (4) to the
sensor wire bracket.
Install the silencer case (page 5-83).
INTAKE MANIFOLD REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– L. engine under cover (page 6-4)
– Throttle body (page 5-85)
Disconnect the pressure regulator control tube (1) from
the intake manifold joint (2).
Remove the two bolts (1) and slide the L. side cover
bracket (2).
FUEL SYSTEM
(1)
(1)
(2)
(3)
(1)
(2)
(4)
(1)
(2)
(2)
5-87