TOHATSU BFT115A Service Manual page 275

Insert the inner cable end of cover lock cable B (1) into
the L. side lock (2).
Install cover lock cable B to the L. side cover bracket
(3), and tighten the washer side lock nut (4) to the
specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
• After tightening the lock nut, check that the adjusting
nut position is not changed from the previous step.
If changed, readjust the cable.
Insert the inner cable end of cover lock cable B (1) into
the R. side lock (2).
Install cover lock cable B to the R. side cover bracket
(3), and tighten the washer side lock nut (4) to the
specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
• After tightening the lock nut, check that the adjusting
nut position is not changed from the previous step.
If changed, readjust the cable.
There should be no clearance (5) between the hole of
the R. side lock and cable end of the cover lock cable B,
and check that the R. side lock is contacting the stopper
(6) of the R. side cover bracket.
There should be no clearance (7) between the hole of
the L. side lock (8) and cable end of the cover lock
cable B (9), and recheck that the L. side lock is
contacting the stopper (10) of the L. side cover bracket.
Readjust the cable if there is clearance.
After installing the cables, operate the cover lock levers
and check that the front lock and L./R. side locks
operates smoothly.
Also check that the front lock and side lock (1) is not
visible from each cover lock bolt insertion hole (2) of the
under cover front bracket and L./R. side cover bracket,
when operating the levers, viewed from straight above
the holes.
Readjust the cables if the front lock and/or side lock is
visible.
Install the following:
– L. engine under cover (page 6-6)
– R. engine under cover (page 6-11)
– Front separate cover (page 6-3)
– Engine cover
ENGINE COVER/COVER LOCK
(2)
(4)
(3)
(1)
(1)
(5)
(8)
(7)
(1)
(4)
(3) (1)
(6)
(2)
(6)
(2)
(10)
(9)
(2)
6-17